Picture
The AccuWire™ is designed to give you an accurate measurement (27’ from front of the board to front of board) between your cornhole boards each time you play. Please read the directions below before assembling this product.

Warning: Eye protection should be worn during assembly of this product. Use caution when cutting zip ties to uncoil the wire. The wire may contain sharp edges and should be handled with care. 

Included in the package

  • Burlap carrying bag
  • Eye bolt (2)
  • Eye bolt nut (2)
  • Washer (2)
  • Wire - coated vinyl
  • Cable loop sleeve (2)
  • Spring link (2)

Tools needed

  • Power drill
  • ¼ inch drill bit
  • Crimper or vice grips
  • 27’+ Tape measure
  • Wire cutters

Assembly instructions

Installing eye bolts
  1. Drill hole in the front center of board #1
  2. Insert eye bolt (A) through drilled hole
  3. Place washer (C) on back side of eye bolt and then tighten eye bolt nut (B)
  4. Repeat steps 1-3 with board #2

Installing wire
  1. oop one end of the wire (D) through one cable loop sleeve (E)
  2. Attach one spring link (F) and pull the wire (D) tight
  3. Use a crimper or vice grips to secure the cable loop sleeve (E) to the wire (D)
  4. Hook the spring link (F) to the eye bolt (A) of board #1
  5. Measure 27 feet to make sure that boards #1 and #2 are the correct distance apart
  6. Loop the other end of the wire (D) through the second cable loop sleeve (E) leaving enough slack to adjust to the correct distance between the boards
  7. Attach the second spring link (F) to the wire (D)
  8. Hook the second spring link (F) to the second eye bolt (A) of board #2
  9. Adjust the wire (D) so that it is taut between the two boards
  10. Use a crimper or vice grips to secure the cable loop sleeve (E) to the wire (D)
  11. Trim excess wire from the ends of each wire